ADSBee 1090 Enclosure (Single SMA Connector) 3D-printed PETG enclosure for an ADSBee 1090 single-band receiver. Includes a pre-installed SMA to U.FL bulkhead connector and 4x M2.5 socket-head mounting screws. NOTE: Does not include an FPC WiFi antenna (these are shipped with the receiver PCBAs).

ADSBee 1090 PoE Pant PoE pant for running the ADSBee 1090 / 1090U from an IEEE 802.3af Power over Ethernet (PoE) connection. Includes standoffs and mounting screws for attaching the ADSBee. To connect the ADSBee via Ethernet once the PoE pant is installed, disable the WiFi station and access point and enable Ethernet with the following commands:  AT+WIFI_STA=0  AT+WIFI_AP=0  AT+ETHERNET=1  Note that this pant requires 13×2.54mm through-hole pin headers to be soldered to the ADSBee 1090U (included with the pant).

W.FL / MHF3 / MHF4 Connector Removal / Installation Tool Use this handy tool to remove the WiFi antenna cable from the ADSBee 1090’s WiFi module.Removing the WiFi antenna cable is the trickiest part of disassembling an ADSBee 1090, and carries about a 50% chance of destroying the connector on the WiFi module if it’s done without the proper tool (ask me how I know)!This tool is highly recommended if you’re planning to transfer your ADSBee 1090 to a new enclosure or disconnect its WiFi antenna connector for any reason. The tool includes arms that can be slid under the wings on an MHF3 plug, allowing it to be removed from an MHF3 jack without damage. The tool also includes an arm that secures the MHF3 plug from above, allowing the same tool to be used when aligning and installing an MHF3 plug onto its mating jack. Note: this tool is technically an MHF4 removal tool, but it works well enough for MHF3 (and dedicated MHF3 tools are impossible enough to find) that I’ve been carrying it in the store.Datasheet:https://www.i-pex.com/sites/default/files/downloads/pdf/2D_MHF_4_MATING_AND_UNMATING_TOOL_1_90435C2.pdfI-Pex 90435-001 MHF 4 CONNECTOR MATING/UNMATING Tool